[Users] Binary Neutron Star evolution with Gamma-Law EOS

Petr Tsatsin ptsatsin at my.fau.edu
Tue Nov 26 11:21:33 CST 2013


Hello Vassili,
No, I don't think I'm using it. I'll try it to see if it fixes the problem.
Thank you.
Petr.


On Tue, Nov 26, 2013 at 12:18 PM, Vassilios Mewes <vassilios.mewes at uv.es>wrote:

> Hello Petr,
>
> are you using the
>
> GRHydro::reconstruct_Wv = yes
>
> parameter?
> I need to use it in my accretion disk runs when using the Ideal_Fluid
> EOS...Using the polytrope this parameter wasn't needed if I recall
> correctly..
>
> hope this helps..
>
> best wishes,
>
> Vassili
>
>
> On Tue, Nov 26, 2013 at 6:00 PM, Petr Tsatsin <ptsatsin at my.fau.edu> wrote:
>
>> Hello,
>> I've recently tried to perform simulation of the binary neutron stars
>> started from Meudon initial data. I've encountered a following problem. I
>> can run the simulations without any problems when I use polytropic EOS.
>> However, when I switch to Gamma-Law simulations crushed  soon after start
>> somewhere in the conversion of primitive quantities to conserved
>> quantities. The typical log is look like this one:
>>
>> WARNING[L1,P28] (GRHydro): Con2Prim failed; stopping the code.
>> WARNING[L1,P28] (GRHydro): Even with mesh refinement, this point is not
>> restricted from a finer level, so this is really an error
>> WARNING[L1,P28] (GRHydro):             on carpet reflevel:  2
>> WARNING[L1,P28] (GRHydro):                   xyz location:
>> 12.00000        0.000000       -2.000000
>> WARNING[L1,P28] (GRHydro):                         radius:     12.16553
>> WARNING[L1,P28] (GRHydro): hydro_excision_mask, C2Pfailed:   0   1.0000000
>> WARNING[L1,P28] (GRHydro):        rho eps press w_lorentz:
>> 0.1047685E-08   0.5280317E-01   0.5532109E-10    1.013257
>> WARNING[L1,P28] (GRHydro):                     velocities:
>> -0.3371566E-02   0.1176264      -0.3492353E-01
>> WARNING[L1,P28] (GRHydro):                       dens tau:
>> 0.2037191E-08   0.1388378E-09
>> WARNING[L1,P28] (GRHydro):                           scon:
>> -0.2835004E-10   0.4723716E-09  -0.1051106E-09
>> WARNING[L1,P28] (GRHydro):                       3-metric:
>> 1.420906      -0.7104738E-01  -0.2077218E-01    1.770598
>> 0.4372303E-01    1.468061
>> WARNING[L1,P28] (GRHydro):                   lapse, shift:
>> 0.8118283       0.1691328E-01  -0.3824454E-01  -0.5210642E-03
>> WARNING level 0 in thorn GRHydro processor 28 host
>> c559-402.stampede.tacc.utexas.edu
>>   (line 2404 of GRHydro_Con2Prim.F90):
>>   -> Aborting.
>> cactus_SBNS:
>> /work/02566/tsatsin/Cactus/arrangements/Carpet/Carpet/src/helpers.cc:314:
>> int Carpet::Abort(const _cGH *, int): Assertion `0' failed.
>>
>> The parameter files for "polytropic" runs and "Gamma-Law" are identical
>> except, obviously, the parameters controlling the EOS.
>> I was wondering if somebody experienced similar problems before? I would
>> be very grateful for any help and suggestions.
>> I also include the some relevant parameters I used for "Gamma-law" EOS
>> below. May be I'm missing some important parameters or values are not
>> properly set?
>>
>>  # Hydro paramters
>> ActiveThorns = "EOS_Omni"
>> EOS_Omni::poly_k = 123.6
>> EOS_Omni::poly_gamma = 2.0
>> EOS_Omni::gl_k = 123.6
>> EOS_Omni::gl_gamma = 2.0
>>
>> ActiveThorns = "GRHydro"
>>
>> GRHydro::initial_Gamma = 2.0
>>
>> HydroBase::evolution_method      = "GRHydro"
>>
>> #GRHydro::riemann_solver            = "Marquina"
>> GRHydro::riemann_solver     = "HLLE"
>> GRHydro::GRHydro_eos_type   = "General"
>> GRHydro::GRHydro_eos_table  = "Ideal_Fluid"
>> GRHydro::recon_method       = "ppm"
>> GRHydro::GRHydro_stencil    = 3
>> GRHydro::bound              = "flat"
>> GRHydro::rho_abs_min        = 1.e-10
>> #GRHydro::GRHydro = 18 # Tmunu(10), rho,press,eps,w_lorentz,vel, tau
>> #GRHydro::GRHydro    = 10    # gij(6), alpha, beta(3)
>>
>> GRHydro::c2p_reset_pressure        = "yes"
>> grhydro::grhydro_c2p_warnlevel         =  0
>> grhydro::grhydro_c2p_warn_from_reflevel      =  2
>>
>>
>> ActiveThorns = "GenericFD NewRad"
>> ActiveThorns = "ML_BSSN ML_BSSN_Helper"
>> ActiveThorns = "ML_ADMConstraints"
>>
>>
>> Thank you and Happy Thanksgiving.
>> Petr.
>> --
>> Petr Tsatsin
>> Graduate Student - Department of Physics
>> Charles E. Schmidt College of Science
>> Florida Atlantic University
>> (561)-297-3386
>>  cell: 1-561-299-8048
>> ptsatin at fau.edu, ptsatsin at gmail.com
>>
>> _______________________________________________
>> Users mailing list
>> Users at einsteintoolkit.org
>> http://lists.einsteintoolkit.org/mailman/listinfo/users
>>
>>
>


-- 
Petr Tsatsin
Graduate Student - Department of Physics
Charles E. Schmidt College of Science
Florida Atlantic University
(561)-297-3386
cell: 1-561-299-8048
ptsatin at fau.edu, ptsatsin at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.einsteintoolkit.org/pipermail/users/attachments/20131126/fdc870d3/attachment.html 


More information about the Users mailing list